[megoldva] rTorrent nem kapcsolódik

Fórumok

Sziasztok!

Telepítettem kíváncsiságból egy rtorrent-et. Elindul, de nem kapcsolódik. Van "connecting to ...." de nem csinál semmit.

Vajon hogyan lehetne működésre bírni?

Köszönettel:
KJ

Hozzászólások

Milyen linux (aka. melyik distro?)? Melyik rtorrent? (verzio)... "Nem kapcsolodik"..ezt pontosabban? Koszi. :)

Pingelni tudom.
De a Debian torrentet sem tölti le. Csak kapcsolódni próbál.
Van egy rtwi is beállítva, ott meg a nevet sem írja ki.
De enélkül is mennie kellene az rtorrentnek.
Ez itt a tfalálomra beállított .rtorrent.rc tartalma:

# This is an example resource file for rTorrent. Copy to
# ~/.rtorrent.rc and enable/modify the options as needed. Remember to
# uncomment the options you wish to enable.

#scgi_local = ~/torrent/.socket/rpc.socket
scgi_port = localhost:5000

# Maximum and minimum number of peers to connect to per torrent.
min_peers = 40
max_peers = 100

# Same as above but for seeding completed torrents (-1 = same as downloading)
min_peers_seed = 10
max_peers_seed = 50

# Maximum number of simultanious uploads per torrent.
max_uploads = 15

# Global upload and download rate in KiB. "0" for unlimited.
download_rate = 128
upload_rate = 64

# Default directory to save the downloaded torrents.
directory = /home/kovacsj/torrent/download

# Default session directory. Make sure you don't run multiple instance
# of rtorrent using the same session directory. Perhaps using a
# relative path?
session = ~/torrent/.session

# Watch a directory for new torrents, and stop those that have been
# deleted.
# schedule = watch_directory,5,5,load_start=./watch/*.torrent
#schedule = untied_directory,5,5,stop_untied=

# Close torrents when diskspace is low.
#schedule = low_diskspace,5,60,close_low_diskspace=100M

# Stop torrents when reaching upload ratio in percent,
# when also reaching total upload in bytes, or when
# reaching final upload ratio in percent.
# example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
#schedule = ratio,60,60,"stop_on_ratio=200,200M,2000"

# The ip address reported to the tracker.
#ip = 127.0.0.1
#ip = rakshasa.no

# The ip address the listening socket and outgoing connections is
# bound to.
# bind = 127.0.0.1
bind = xxx.xxx.xxx.xxx

# Port range to use for listening.
port_range = 6890-6990

# Start opening ports at a random position within the port range.
#port_random = no

# Check hash for finished torrents. Might be usefull until the bug is
# fixed that causes lack of diskspace not to be properly reported.
#check_hash = no

# Set whetever the client should try to connect to UDP trackers.
use_udp_trackers = yes

# Alternative calls to bind and ip that should handle dynamic ip's.
#schedule = ip_tick,0,1800,ip=rakshasa
#schedule = bind_tick,0,1800,bind=rakshasa

# Encryption options, set to none (default) or any combination of the following:
# allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
#
# The example value allows incoming encrypted connections, starts unencrypted
# outgoing connections but retries with encryption if they fail, preferring
# plaintext to RC4 encryption after the encrypted handshake
#
# encryption = allow_incoming,enable_retry,prefer_plaintext

# Enable DHT support for trackerless torrents or when all trackers are down.
# May be set to "disable" (completely disable DHT), "off" (do not start DHT),
# "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
# The default is "off". For DHT to work, a session directory must be defined.
#
dht = auto

# UDP port to use for DHT.
#
dht_port = 6881

# Enable peer exchange (for torrents not marked private)
#
# peer_exchange = yes

#
# Do not modify the following parameters unless you know what you're doing.
#

# Hash read-ahead controls how many MB to request the kernel to read
# ahead. If the value is too low the disk may not be fully utilized,
# while if too high the kernel might not be able to keep the read
# pages in memory thus end up trashing.
hash_read_ahead = 10

# Interval between attempts to check the hash, in milliseconds.
hash_interval = 100

# Number of attempts to check the hash while using the mincore status,
# before forcing. Overworked systems might need lower values to get a
# decent hash checking rate.
hash_max_tries = 10

Bithumen fórumán nemrég volt egy hasonló probléma, a megoldás:

"a legújabb rTorrent 0.8.4/0.12.4 -hez a libcurl3 -at frissítenem kellett 7.18.2-7 -re (compile előtt), mert amúgy 1 trackerhez sem tudott kapcsolódni"

Nekem 0.8.2-vel tökéletesen megy már régóta, így nem tudom ez tényleg működik-e, de egy próbát megér.

Sietek megköszönni! A 0.8.2-essel már működik.
Az rtwi-vel vannak gondjaim most. A torrent fájlt fel tudom tölteni, de a le- és feltöltésről nem közvetít semmiféle információt. Tud ebben valaki segíteni? Vagy ez már egy másik topic-ot igényel?

Az is megoldódott. A /home/user/ könyvtár nem volt beállítva.
Köszönök mindent!
Boldog Új Évet Mindenkinek!