sigmatel USB/MSC pendrive mount

Merevlemezek, vezérlők

Sziasztok a fent nevezett azközt szeretném felcsatlakoztatni, az lsusb látja, de /dev/sdax ezköz nem található?? Tud valaki tippet adni mit tehetnék?
Köszönöm szépen :)

  • 5074 megtekintés

16 heads, 63 sectors/track, 116280 cylinders
Units = cilinderek of 1008 * 512 = 516096 bytes

Eszköz Boot Start End Blocks Id System
/dev/hda1 * 1 8718 4393746 83 Linux
/dev/hda2 8718 9706 498015 82 Linux swap / Solaris
/dev/hda3 9706 116280 53713327+ 83 Linux
Partition 3 does not end on cylinder boundary.

SAjna nem :(
más özlet? kösz

Ebből mit kell kiolvasni?

Sajna ettől én nem lettem okosabb, de hátha valaki más :)
köszke

[17179576.764000] usbcore: registered new driver usbfs
[17179576.764000] usbcore: registered new driver hub
[17179576.764000] usb usb1: configuration #1 chosen from 1 choice
[17179576.868000] usb usb2: configuration #1 chosen from 1 choice
[17179576.972000] usb usb3: configuration #1 chosen from 1 choice
[17179577.092000] usb usb4: configuration #1 chosen from 1 choice
[17179577.108000] usb 1-2: new low speed USB device using uhci_hcd and address 2
[17179577.724000] usb 4-4: new high speed USB device using ehci_hcd and address 3
[17179577.856000] usb 4-4: configuration #1 chosen from 1 choice
[17179578.096000] usb 1-2: new low speed USB device using uhci_hcd and address 3
[17179578.272000] usb 1-2: configuration #1 chosen from 1 choice
[17179589.536000] usbcore: registered new driver hiddev
[17179589.552000] input: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb-0000:00:1d.0-2
[17179589.552000] usbcore: registered new driver usbhid
[17179589.552000] drivers/usb/input/hid-core.c: v2.6:USB HID core driver
[17179590.172000] usbcore: registered new driver zd1211rw
[17185884.680000] usb 1-2: USB disconnect, address 3
[17185890.288000] usb 4-1: new high speed USB device using ehci_hcd and address 4
[17185890.420000] usb 4-1: configuration #1 chosen from 1 choice
[17185890.536000] usbcore: registered new driver libusual
[17185890.628000] usbcore: registered new driver usb-storage
[17185890.628000] usb-storage: device found at 4
[17185890.628000] usb-storage: waiting for device to settle before scanning
[17185895.628000] usb-storage: device scan complete
[17185895.672000] sda:<6>usb 4-1: reset high speed USB device using ehci_hcd and address 4
[17185926.028000] usb 4-1: reset high speed USB device using ehci_hcd and address 4
[17185936.272000] usb 4-1: reset high speed USB device using ehci_hcd and address 4
[17185941.516000] usb 4-1: reset high speed USB device using ehci_hcd and address 4
[17185971.760000] usb 4-1: reset high speed USB device using ehci_hcd and address 4
[17185976.972000] usb 4-1: USB disconnect, address 4
[17185988.500000] usb 1-2: new low speed USB device using uhci_hcd and address 4
[17185988.676000] usb 1-2: configuration #1 chosen from 1 choice
[17185988.696000] input: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb-0000:00:1d.0-2
[17193606.528000] usb 4-1: new high speed USB device using ehci_hcd and address 6
[17193606.660000] usb 4-1: configuration #1 chosen from 1 choice
[17193606.660000] usb-storage: device found at 6
[17193606.660000] usb-storage: waiting for device to settle before scanning
[17193611.660000] usb-storage: device scan complete
[17194121.376000] usb 4-1: USB disconnect, address 6
[17194788.156000] usb 4-1: new high speed USB device using ehci_hcd and address 7
[17194788.288000] usb 4-1: configuration #1 chosen from 1 choice
[17194788.288000] usb-storage: device found at 7
[17194788.288000] usb-storage: waiting for device to settle before scanning
[17194793.288000] usb-storage: device scan complete
[17194957.512000] usb 4-1: USB disconnect, address 7

A dmesg output-ban az usb-storage után levő SCSI üzeneteket keresd, nálam pl: 


usb 2-4: new high speed USB device using ehci_hcd and address 4
Real Time Clock Driver v1.12ac
usb 2-4: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 4
usb-storage: waiting for device to settle before scanning
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
USB Universal Host Controller Interface driver v3.0
  Vendor: HTS54808  Model: 0M9AT00           Rev: MG4O
  Type:   Direct-Access                      ANSI SCSI revision: 02
usb-storage: device scan complete
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
sda: Write Protect is off
sda: Mode Sense: 53 00 00 08
sda: assuming drive cache: write through
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
sda: Write Protect is off
sda: Mode Sense: 53 00 00 08
sda: assuming drive cache: write through
 sda: sda1
sd 0:0:0:0: Attached scsi disk sda

A fentiben azt látod, hogy az új sda eszközön egy sda1 partíció van, ezt tudom mountolni.
Pendriveoknál megszokott, hogy nincs particionálva, az sda-t kell pl. mountolni.

[17180787.544000] usb 4-1: configuration #1 chosen from 1 choice
[17180787.668000] usbcore: registered new driver libusual
[17180787.756000] SCSI subsystem initialized
[17180787.756000] Initializing USB Mass Storage driver...
[17180787.760000] scsi0 : SCSI emulation for USB Mass Storage devices
[17180787.760000] usbcore: registered new driver usb-storage
[17180787.760000] USB Mass Storage support registered.
[17180787.760000] usb-storage: device found at 5
[17180787.760000] usb-storage: waiting for device to settle before scanning
[17180792.760000] usb-storage: device scan complete
[17180792.760000] Vendor: SigmaTel Model: MSCN Rev: 0100
[17180792.760000] Type: Direct-Access ANSI SCSI revision: 04
[17180792.804000] SCSI device sda: 243968 2048-byte hdwr sectors (500 MB)
[17180792.804000] sda: Write Protect is off
[17180792.804000] sda: Mode Sense: 3e 00 00 00
[17180792.804000] sda: assuming drive cache: write through
[17180792.808000] SCSI device sda: 243968 2048-byte hdwr sectors (500 MB)
[17180792.808000] sda: Write Protect is off
[17180792.808000] sda: Mode Sense: 3e 00 00 00
[17180792.808000] sda: assuming drive cache: write through
[17180792.808000] sda:<6>usb 4-1: reset high speed USB device using ehci_hcd and address 5

[17180787.544000] usb 4-1: configuration #1 chosen from 1 choice
[17180787.668000] usbcore: registered new driver libusual
[17180787.756000] SCSI subsystem initialized
[17180787.756000] Initializing USB Mass Storage driver...
[17180787.760000] scsi0 : SCSI emulation for USB Mass Storage devices
[17180787.760000] usbcore: registered new driver usb-storage
[17180787.760000] USB Mass Storage support registered.
[17180787.760000] usb-storage: device found at 5
[17180787.760000] usb-storage: waiting for device to settle before scanning
[17180792.760000] usb-storage: device scan complete
[17180792.760000] Vendor: SigmaTel Model: MSCN Rev: 0100
[17180792.760000] Type: Direct-Access ANSI SCSI revision: 04
[17180792.804000] SCSI device sda: 243968 2048-byte hdwr sectors (500 MB)
[17180792.804000] sda: Write Protect is off
[17180792.804000] sda: Mode Sense: 3e 00 00 00
[17180792.804000] sda: assuming drive cache: write through
[17180792.808000] SCSI device sda: 243968 2048-byte hdwr sectors (500 MB)
[17180792.808000] sda: Write Protect is off
[17180792.808000] sda: Mode Sense: 3e 00 00 00
[17180792.808000] sda: assuming drive cache: write through
[17180792.808000] sda:<6>usb 4-1: reset high speed USB device using ehci_hcd and address 5

ezt találtam, meg esetleg ez:
[17180823.164000] usb 4-1: reset high speed USB device using ehci_hcd and address 5

Köszönöm:)

( tiger | 2006. 12. 20., sze – 17:58 )

Nekem is ilyen pendrive-om (pontosabban mp3 lejátszóm volt. Nem is tudtam belőni, egynap tönkrement a jack csatlakozója és garanciálisan kicserélték, amit kaptam ugyanaz a modell volt, de újabb firmware-el. Azóta müxik (meg látja az id3-at meg lejátsza a wma-t :) )

Hozzáteszem, hogy eredetileg ami windows alatt egy particiónak látszott az négy darab volt, legalábbis alinuxos fdisk szerint. egyszer letöröltem róla azokat a particiókat és csináltam rá egy darabot, amit fatnak formáztam. A lejátszó bekapcsolás után nem ismerte fel, hogy lenne rajta vmi. Letöröltem a particiókat, bekapcsoltam és újra létrehozta azt a négyet. Érdekes egy kütyü az biztos (bocs az OFF-ért)