Szia!
Kérnék egy kis segítséget.
A Dialer interface kap v6 címet, de a belső hálózattal nem boldogulok...
#sh ipv6 int di1
Dialer1 is up, line protocol is up
IPv6 is enabled, link-local address is FE80::..
No Virtual link-local address(es):
Description: ---
Stateless address autoconfig enabled
Global unicast address(es):
2A01:36C:..:5E70, subnet is 2A01:36C:..::/64 [EUI/CAL/PRE]
####################################################################
#ping ipv6 hup.hu
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 2001:4C48:2:A33E::6, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms
####################################################################
#sh run int di1
Building configuration...
Current configuration : 487 bytes
!
interface Dialer1
ipv6 address dhcp
ipv6 address autoconfig
ipv6 enable
ipv6 dhcp client pd PD rapid-commit
####################################################################
#sh run int bvi1
Building configuration...
Current configuration : 414 bytes
!
interface BVI1
description --- INET BRIDGE IP IFACE ---
ipv6 address PD ::1/64
ipv6 enable
ipv6 nd other-config-flag
####################################################################
Mit rontok el? (a bridge interfészre nem ér panaszkodni, ugyanez van SVI-n is. Amúgy 1812W advipservicesk9-mz.124-24.T3)