# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.4.0-1 (October 7, 2008)
Bonding Mode: IEEE 802.3ad Dynamic link aggregation
Transmit Hash Policy: layer2 (0)
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 0
Down Delay (ms): 0
802.3ad info
LACP rate: slow
Active Aggregator Info:
Aggregator ID: 1
Number of ports: 2
Actor Key: 17
Partner Key: 2
Partner Mac Address: 64:00:f1:1b:96:80
Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 3c:4a:92:77:22:a6
Aggregator ID: 1
Slave Interface: eth2
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 3c:4a:92:77:22:aa
Aggregator ID: 2
Slave Interface: eth4
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 1
Permanent HW addr: 00:26:55:e4:95:a9
Aggregator ID: 1
Slave Interface: eth8
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:26:55:e4:93:81
Aggregator ID: 2
hát ez van a bond0-ban. jónak nézki. legalább is nekem.
a no route to host a message logból jön a dmesg-ben pedig csak a iSCSI timeout van ami ugye a hálózat kiesés miatt történt.
--
A legértékesebb idő a pillanat amelyben élsz.
https://sites.google.com/site/jupiter2005ster/