a man-ban elvileg le van irva esetleg nezd meg azt. az 5.38 egyebkent kb 1.5 eves kiadas azota eleg sokmindent fejlesztettek. az ilyenek miatt tervezem a visszaallast forras alapu disztrora
szerk:
A man-ban van meg bovebb leiras, ezert fejleszthetik lassan:
The ´usbcypress´ device type is for ATA disks that are behind a Cypress usb-pata bridge. This will use the
ATACB proprietary scsi pass through command. There is no autodetection at the moment. The best way to know
if your device support it, is to check your device usb id (most Cypress usb ata bridge got vid=0x04b4,
pid=0x6830) or to try it (if the usb device doesn't support ATACB, smartmontools print an error). The
default scsi operation code is 0x24, but although it can be overridden with ´-d usbcypress,0xn´, where n
is the scsi operation code, you're running the risk of damage to the device or filesystems on it.
[NEW EXPERIMENTAL SMARTCTL FEATURE] The ´usbjmicron´ device type is for SATA disks that are behind a JMi‐
cron USB to PATA/SATA bridge. The 48-bit ATA commands (required e.g. for ´-l xerror´, see below) do not
work with all of these bridges and are therefore disabled by default. These commands can be enabled by ´-d
usbjmicron,x´. CAUTION: Specifying ´,x´ for a device which do not support it results in I/O errors and may
disconnect the drive. The port can be specified by ´-d usbjmicron[,x],PORT´ where PORT is 0 (master) or 1
(slave). This is not necessary if only one disk is connected to the USB bridge. If two disks are con‐
nected, an error message is printed if no PORT is specified.
udv Zoli